The ESD Store

Staticide® ESD Safety Shield CLEARly the best static protective coating for plastics that has never been seen! ACL Staticide® presents a family of coatings that gives long-lasting protection and will not wash off with water as an anti-stat would. Topical anti-stats are biodegradable and need reapplication after a few weeks whereas Staticide® ESD Safety Shield provides dependable protection by allowing static to dissipate at a safe rate regardless of relative humidity and without reapplication. The advanced formulas are blended from durable polymer materials that are safe to use in ESD controlled environments where contamination is a concern. These single-coat systems are flexible enough for soft plastics like tubing, clamshell protective packaging, carrying trays and lids and they dry with a see-through clarity that surpasses any ambient cure coating on the market.* Easy to apply, Staticide® ESD Safety Shield can be brushed, dipped or sprayed and provides excellent adhesion to a variety of plastics without any special cure treatment. So defend your plastic parts, bins and shelving against static with Staticide® ESD Safety Shield Features and Benefits Static Dissipative Translucent Durable Adhesion Customize No Contaminants Easy to Apply *Easy to Use For more information contact: Provides a surface resistivity of 105 ? 107 ohms/sq Perfect for viewing ports on machines Doesn?t chip or peel and is able to withstand normal handling without scratching Bonds to a variety of plastics Special formulations available for lower resistance and complex plastics No silicone, No chlorides No special equipment necessary 6300 has no special drying requirements 6400 requires a low temperature heat cure Staticide ESD Safety Shield PHYSICAL PROPERTIES Resistivity Weight/Gallon Range : 8.7-9.1 lbs Coverage (foam brush) : 1500 sq. ft. / gallon @ .5 mil dry (approx) Coverage (flow coat) : 600 sq. ft. / gallon @ 1.5 mil dry (approx) VOC Range : 1.18 lbs / liter Freeze Thaw Cycle Contaminants : No Chlorides, No Silicone Abrasion Resistance : Coating exhibits resistance to abrasion that is similar to or better than that observed on bare substrate Solvent Resistance - Coated panel was submerged in a 50/50 mix of isopropyl alcohol and water for 30 minutes to no effect Do not Freeze 93 ? 96% T measured by UV Spectra